Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Shape
4.4

Tension test

PROLITE-40 fusion splicer supply the function of tension test. If you need this
function, when you enter into
machine will do tension test. After you start the machine, the screen displays as left
picture:
Page 16
Reason
1. There is dust on the
end-face
2. Dew.
3. Bad fiber's end-surface.
4. Too small arc current.
1. Too large arc current.
2. Too small push speed.
3. Little fusion push.
4. Feed blocked.
Note: Black line will
appear on fiber's joint
with fluorine, it has no
effect to transport
characteristic.
Table 4.-
, please open this function, and after each splicing,
Figure 8.-
USER'S MANUAL. PROLITE-40
Measure
1. Remake end-surface.
2.
Adjust
program
current.
(Optimization
parameter)
1.
Adjust
program
current parameter.
(Optimization
parameter)
2. Clean V-groove.
Press
to arc again
and observe.
or
of
arc
or
of
arc
02-2011

Capítulos

Tabla de contenido
loading

Tabla de contenido