Promax PROLITE-40 Manual De Instrucciones página 123

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

USER'S MANUAL. PROLITE-40
Unusual condition
16.- The splicing
1. There is dust in V
groove.
index is too large.
(actual measure)
2. Improper current.
3. The fiber is not aligned.
4. The electrode doesn't
work well.
5.
program parameter.
6. Unqualified end face.
The cleaver is not good.
7. Special fiber.
8. Bad environment.
1.
17.- (1) The heat
LED doesn't work,
damaged.
but it can heat; or
2. The heat key is stuck by
the
index
light
something hard.
buzzer and heater
don't work.
(2) The heat LED
and
buzzer
work
well, but the heater
doesn't work.
18.- Can't achieve
arc in fusion and
1. When press the
current
test
or
and the machine is in
something
wrong
mode of auto splice,
happen.
is pressed by mistake.
2. When press
the machine is in arc test,
mistake.
02-2011
The possible problem
Improper
setting
of
The
heat
key
is
and
is
pressed
by
Solution
1. Clean the V-groove, lens
or electrode.
2. Select proper program to
arc.
3. Adjust the cleaver.
4. If the splicing index is
too large, change the value
of "Pre-fusion current" or
"Fusion push", find proper
program.
5. Make sure that the wind
power is proper.
1. Press
several
times, If it doesn't work,
contact us.
1. Don't press
when
pressing the
(
and the machine is in
mode of auto splice.
Remark
All problems are
caused by inner
circuit
fault
probably. If you
couldn't
solve
the
problems,
please sent it to
us with detailed
explanation.
)
Page 49

Capítulos

Tabla de contenido
loading

Tabla de contenido