Promax PROLITE-40 Manual De Instrucciones página 131

USER'S MANUAL. PROLITE-40
6. Place the bare fiber in the fiber cutter. Place the cross section, with the
coverage at 17 mm from the blade. The fiber has to be as perpendicular as
possible to the blade. If the fiber has tensions that make it bend then you
should move the blade forward. Try to rotate the fiber to adopt a
perpendicular position and then move down the fixing lever to its top without
sudden shocks. Then move the blade back and the piece that secures the
"naked" optical fiber down.
7. Place the end of the fiber, which should already be peeled and cut, into the
splicer. Turn on the splicer using the lateral switch, lift the centre lid and the
left side cover to fix the Optical fiber. The end of the fiber must be just in the
line that connects both terminals. By lowering the cap of the splicer you can
check the cut and cleanliness of the fiber. If you see cuts at angles, gaps or
dirt is better to repeat the whole process again, from peeling.
02-2011
Figure 26.-
Figure 27.-
Page 57