Promax PROLITE-40 Manual De Instrucciones página 120

Unusual condition
5.- Press , fiber
image of one Side
moved vertically,
and could not
splice.
6.- After splicing,
displayed big loss
or failed splicing.
7. Always display
bad fiber end-face
of one side.
8. The value of
tested current is
too big or too
small.
Page 46
The possible problem
1. There is dust in the V-
groove, which leads to the
position of fiber is too
higher than another side.
2. There is dust on lens,
light or reflector.
1. The fiber is dirty, the
end-face is unqualified, or
there is fault in the cleaver.
2. There is dust on the
lens, light or reflector.
1. The value of "Setting
end-face" is too small.
2. There is dust on the
Lens, lights or reflector.
3. The light is dim.
4. There is dust in V
groove or fiber isn't put
properly.
1. The value of "fusion
current" are too large or
too small.
2. Too much sediment on
the electrode.
3. The relative position
between fiber and arc has
changed.
4. The storage battery
doesn't work well.
5. The environment has
changed.
USER'S MANUAL. PROLITE-40
Solution
1. Wipe V-groove at single
direction with tool several
times.
2. Clean lens, prism and
two lights with cleanly
cotton several times.
3. If it doesn't work, contact
us.
1. Adjust fiber cleaver,
make qualified fiber end-
face.
2. Clean the lens, reflector
and two lights with cleanly
cotton several times.
3. If it doesn't work, contact
us.
1. Enter the menu; add the
value of "Setting end face".
Clean the lens, the light
and the reflector, clean the
V groove and try again. If it
doesn't work, contact us.
1. Enter the menu and
clean electrode several
times.
2. Or select "electrodes
aging" and check whether
the arc is steady. Then
select Program 3 to test
arc again.
3. Test the current until it is
proper.
4. If it doesn't work, contact
us.
Remark
All problems are
caused by inner
circuit fault
probably. If you
couldn't solve
the problems,
please sent it to
us with detailed
explanation.
02-2011