Promax PROLITE-40 Manual De Instrucciones página 132

8. Repeat this procedure for the other end of the Optical fiber that you want to
splice. Finally, both ends of the Optical fiber should be near the centre line
that connects both terminals. Moving down the lid of the splicer, you could
see the level of cleanliness and the cut made on the optical fiber.
Figure 28.-
9. If both cuts are correct and the fiber is not dirty you can start to splice by
pressing
After that, an electric arc melts both ends and splices them.
Page 58
. The first stage is a small discharge to clean the optical fiber.
Figure 30.-
USER'S MANUAL. PROLITE-40
Figure 29.-
02-2011