Cleaning The Hood - THERMEx SDD-4 Istrucciones De Uso

CLEANING
THE HOOD
Careful maintenance helps guarantee proper operation and good results from an appliance over time.
The hood must be unplugged from the electrical power source, both by unplugging the appli-
ance from the socket as well as de-activating the breaker, before removing the metal filters.
After cleaning, you must replace the metal filters as outlined in the instructions.
MAINTENANCE
External surfaces and
accessories
Charcoal filter with
extractable
unit open
Active carbon filter
52
CAUTION
HOW TO PROCEED?
Do not use metallic scrubbers, abra-
sive products, or hard brushes.
After 30 hours of functioning, the
downdraft will signal the grease filter
saturation.
The saturation is signaled by the
blinking of the 4 central leds.
For both models, the reset function
is activated by pushing the timer
key while the extractable unit is
open.
In the recirculation mode, you must
substitute the active carbon filter pe-
riodically.
To remove the carbon filter it is nec-
essary first of all to remove the grease
filter and then to pull the plastic key
of the panel itself to remove it from its
seating.
Follow these steps in reverse order to
insert the active carbon filter.
Replace the used carbon filter on an
average of every six months.
ACCESSORY PRODUCTS TO
USE
To clean the external surfaces of the
hood and the light housing screen
use only commercially available
household detergents diluted in wa-
ter. Then rinse with clean water and
dry with a soft cloth.
The grease filters can be washed by
hand or in the dishwasher. These fil-
ters need to be cleaned on a regular
basis because otherwise they may
present a fire risk.
Refit the grease filters and front
panel, making sure that the panel
is properly fitted at the sides so that
it does not cause the downdraft to
stop operating.
S-DD4