Product Identification; Product Features; Unpacking; Assembly Instructions - Outdoor Leisure SPC-21PHTSA El Manual Del Propietario

PrODuCT
IDENTIFICATION
Dome
Reflector
Propane/LP
Cylinder
Housing
Base
Figure 1 - Propane/LP Table Top Patio

PrODuCT FEATurES

SAFETY PILOT
This heater has a pilot with an Oxygen Deple-
tion Sensing (ODS) safety shutoff system.
The ODS/pilot is a required feature for table
top patio heaters. The ODS/pilot shuts off the
heater if there is not enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system
requires no matches, batteries, or other
sources to light heater.
16"
(40.64 cm)
30" (76.20 cm)
Below Burner
Figure 2 - Clearances from Combustibles
114082-01F
Wire
Guard
Control
Knob
Heater
16"
(40.64 cm)
16"
(40.64 cm)
www.desatech.com

uNPACkINg

1. Remove heater from carton.
2. Remove all protective packaging applied
to heater for shipment.
3. Check heater for any shipping damage.
If heater is damaged, promptly return to
dealer where you bought heater.

ASSEMbLy INSTruCTIONS

Tools Required:
• Phillips Head Screwdriver
• Standard Pliers
Inspect heater components for possible ship-
ping damage. If any is found, immediately
notify the dealer. Check to make sure that all
components are included with your heater
(see pages 12 and 13).
1. Attach burner and controls assembly to
base assembly with 4 screws (see Fig-
ure 3). Tighten screws. Place operating
instruction label under control knob for
easy review.
2. Align 3 dome holes with the 3 studs pro-
truding from burner top (see Figure 3).
Place dome onto the studs. Install 3 cap
nuts onto studs. Tighten with pliers.
The installation must conform with local codes
or in the absence of local codes, The National
Fuel Gas Code, ANSI Z223.1.
Cap Nuts
Dome
Reflector
Burner and
Controls
Assembly
Screws
Base
Assembly
Figure 3 - Heater Assembly
5