Product Identification; Unpacking; Assembly - Outdoor Leisure TD101A Manual Del Usuario

SAFETy
Continued
16. Never move, handle, or service a hot
or operating heater. Severe burns may
result. You must wait 20 minutes after
turning heater off.
17. To prevent injury, wear gloves when han-
dling heater.
18. Turn off heater valve and gas supply to
heater when not in use.
19. Use only original replacement parts. This
heater must use design-specific parts.
Do not substitute or use generic parts.
Improper replacement parts could cause
serious or fatal injuries.
0. Certain materials or items, when stored in
front of heater, will be subjected to radiant
heat and could be seriously damaged.
21. Shut heater off immediately if flashback
occurs (flame inside burner tube). Have
heater serviced.
. Never attempt to use heater or any
components that have been damaged or
exposed to accidental fire.
3. If you smell gas or suspect a leak, shut
off propane/LP cylinder valve at once.
Ventilate area. Do not strike a match or
create any flame or electric spark. Find
and correct leak before attempting to light
any appliance.
4. Do not block intake air openings.
25. Use correct pressure specifications, see
page 11.
6. Propane/LP gas cylinder is not provided.
Use a 0 lb. propane/LP gas cylinder
marked propane. The cylinder supply sys-
tem must be arranged for vapor withdrawal.
The cylinder used must include a collar to
protect the cylinder valve. The cylinder must
be provided with a shutoff valve terminating
in a propane/LP gas supply cylinder valve
outlet specified, as applicable, for connec-
tion no. 510 in the Standard for Compressed
Gas Cylinders Valve Outlet and Inlet Con-
nections, ANSI/CGA-V-1, or connection no.
600 in the Compressed Gas Association's
Limited Standard Cylinder Valve Outlet
Connection for Propane Small Valve Series
or combination propane/LP gas cylinder
valve and quick-disconnect assembly
complying with 1.16.5-c and a safety relief
device having a direct communication with
the vapor space of the cylinder.
4
Ignitor
Figure 2 - Infrared Patio Table Heater
1. Remove all packing items applied to
heater for shipment.
. Remove all items from carton.
3. Check all items for shipping damage. If
heater is damaged, promptly inform dealer
where you bought heater.
You should have the following assembly parts:
Table Heater Base (1), Control Panel (1),
Door Panel (1), Lower Panel (1), Lower Sup-
port Pillar (3), Pillar Support Connector (3),
Upper Support Pillar (3), Burner Assembly
(1), Deco Grate Pillar (3), Decorative Grate
(3), Screen (3), Deflector (1), Table Top (1),
Top Bracket (3), Guard Rail (3), Guard Rail
Support Bracket (3), Propane Tank Retention
Chain (1), Retention Hook (), Electronic Ig-
nitor (1), Hardware Package (1) (see pages
1 thru 14).
Estimated assembly time: 55 minutes
Tools required:
• # Phillips screwdriver
• 5 mm and 10 mm Open end wrench
Hardware packet provided with heater may
contain more parts than needed for heater

assembly.

www.desatech.com
PRODUCT
IDENTIFICATION

UNPACkINg

ASSEMBLy
Table
Top
Guard
Rail
Emitter
Decorative
Grate
Control
Knob
1393-01A