Lower Support Legs Automatically; Risk Of Injury - AL-KO UP4 Manual De Instrucciones

CAUTION!
Check that the caravan is uncoupled from the vehicle and that the handbrake has been applied.
Before starting the AL-KO support system, check that the caravan is level using spirit level (7).
Do not use the AL-KO support system to jack up your caravan. The support legs of your caravan
are intended for stabilisation only.
CAUTION!
The AL-KO support system is not intended for jacking up or levelling the caravan.
As soon as the caravan is level, you can use the AL-KO support system.

Lower support legs automatically

ADVICE
The handbrake must be applied before using the system!
1. Turn on battery disconnection switch (1).
2. Push slider switch (2G) on the remote control to "ON" (I).
Green LED (2I) on the remote control has a steady light. The system is ready for operation.
3. Press function selection button (2D) to select "Support system mode".
An acoustic signal sounds.
In "Support system" mode, green control LED (2E) lights up.
4. Hold both automatic lower buttons (2K and 2O) pressed simultaneously for at least 3 seconds.
Blue "Automatic function" LED (2P) flashes and an acoustic signal sounds once a second until
the automatic function starts.
5. After 3 seconds, release automatic lower buttons (2K and 2O).
The support leg pairs (first front, then rear) are lowered automatically.
Blue "Automatic function" LED (2P) has a steady light.
The two support legs adjust themselves slightly.
When all the support legs have been completely lowered, an acoustic signal sounds.
WARNING!

Risk of injury!

The automatic function can be interrupted by pressing any other button!
ADVICE
There is a delay of approx. 3 seconds between pressing the "Automatic" buttons and lowering
of the support legs. If one or more support legs was not fully raised, they will first be raised for
approx. 3 seconds.
CAUTION!
Possible damage to the caravan!
Do not use the support system for jacking up or lifting the caravan!
CAUTION!
Different caravan chassis and caravan floors differ in their characteristics and designs. Impru-
dent use of the function for the individual support legs can result in damage to the caravan
chassis or caravan floor. The setting of the lifting load is designed to protect the motor and the
control unit, but it does not protect your caravan or its chassis from damage.
We recommend that only the automatic function is used for lowering the support legs.
Deactivate the AL-KO support system after use:
1659595_a
1659595_a BA UP4 El_Caravanstütze ESS1 DIN A5 sw.pdf 33
en
33
08.11.2017 11:19:34