AL-KO UP4 Manual De Instrucciones página 28

en
Fig. 2 Designation
I Control unit connection control
LED
J / Q Automatic raise buttons
K / O Automatic lower buttons
L Blue battery LED
Caravan battery
M Blue battery LED
Remote control battery
28
1659595_a BA UP4 El_Caravanstütze ESS1 DIN A5 sw.pdf 28
Function
After switching on the remote control, green control LED (2I) flashes
while the connection is being made to the control unit.
When the connection to the control unit has been made and is ready
for operation, green control LED (2I) has a steady light.
If the connection to the control unit is interrupted, green control LED
(2I) starts to flash again.
1. Hold both automatic raise buttons (2J and 2Q) pressed simulta-
neously for at least 3 seconds.
– Blue "Automatic function" LED (2P) flashes and an acoustic si-
gnal sounds once a second until the automatic function starts.
WARNING!
Risk of injury!
The automatic function can be interrupted by pressing
any other button!
2. After 3 seconds, release automatic buttons (2J and 2Q).
– The support leg pairs (first front, then rear) are raised automa-
tically.
– Blue "Automatic function" LED (2P) has a steady light.
– When all the support legs have been completely raised,
an acoustic signal sounds.
1. Hold both automatic lower buttons (2K and 2O) pressed simulta-
neously for at least 3 seconds.
– Blue "Automatic function" LED (2P) flashes and an acoustic si-
gnal sounds once a second until the automatic function starts.
WARNING!
Risk of injury!
The automatic function can be interrupted by pressing
any other button!
2. After 3 seconds, release automatic buttons (2K and 2O).
– The support leg pairs (first front, then rear) are
lowered automatically.
– Blue "Automatic function" LED (2P) has a
steady light.
– When all the support legs have been completely lowered,
an acoustic signal sounds.
Blue battery LED (2L) lights up if the caravan battery voltage is too high
or too low.
Blue battery LED (2M) flashes (2 Hz) if the voltage of the 9 V battery in
the remote control is too low.
1. Replace the 9 V battery in the remote control.
1659595_a
08.11.2017 11:19:34