Operation - Remote Control - AL-KO UP4 Manual De Instrucciones

en
Do not operate the AL-KO support system if you are under the influence of alcohol, drugs or medi-
cation.
Ensure that no hair, fingers or other limbs, and clothing or other objects can come into contact with
moving parts!
Remember that the AL-KO support system increases the weight of your caravan. This reduces the
caravan's cargo load.
Retract all support legs before manoeuvring or driving away. Failure to do so may result in damage
to the support legs, the caravan or the towing vehicle.
Ensure that the AL-KO support system is switched off at the battery disconnection switch (1) after
use, and that the key is removed and stored safely (out of the reach of children or unauthorised
persons). If the main switch is not turned off, the battery will be gradually discharged as there is a
low power consumption in standby mode.
Ensure that the remote control is kept in a safe place at all times (out of the reach of children or
unauthorised persons). Switch off the remote control after use, as there is a low power consumption
in standby mode and the battery of the remote control will otherwise become discharged.
Do not make any modifications (mechanical or electronic) to the AL-KO support system. Guarantee
claims will not be acknowledged and, if modifications have been made to the AL-KO support system,
we are no longer able to guarantee the function of the device. We accept no liability for damages of
any kind resulting either from incorrect installation, operation or modification.

Operation - remote control

The double-function remote control supplied (2) can be used for the AL-KO "UP4" support system and for
the AL-KO "RANGER" manoeuvring system. The remote control is operated with a PP3 9-Volt battery.
Switching on the remote control
1. Push switch (2G) to "On" - I.
– All control LEDs flash briefly.
– An acoustic signal sounds.
– The green "Support system mode" control LED (2E) lights up.
– Control LED (2I) flashes until a connection has been made to the control unit. When a connection
is made, control LED (2I) has a steady light.
Switching operating modes
2. Press function selection button (2D) to switch from "Support system mode" to "Caravan manoeuvring
mode".
– An acoustic signal sounds.
– Green control LED (2C) now lights up.
The control LEDs indicate the corresponding operating mode:
(2E) "Support system mode"
(2C) "Manoeuvring system mode"
26
1659595_a BA UP4 El_Caravanstütze ESS1 DIN A5 sw.pdf 26
1659595_a
08.11.2017 11:19:34