Installation Diagram Of Indoor And Outdoor Units; Optional Installation Parts - Toshiba 16N3KCV Serie Manual De Instalación

INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS

INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS
8
(
Flat head
Battery cover
wood screw
&
Flat head
wood screw
3
Batteries
2
Wireless remote control
The provided Remote Controller is a
wireless type, which also can be used
as a wire.
Please see "How to Connect The Remote
Controller for Wired Operation", in case of
wired control is required.
Remark :
• Detail of accessory and installation parts can see in
the accessory sheet.
• Some pictures might be different from the actual parts.

Optional Installation Parts

Part
Parts name
code
Refrigerant piping
Liquid side : Ø6.35 mm
Gas side : Ø9.52 mm
A
(RAS-13N3KCV Series)
: Ø12.70 mm
(RAS-16N3KCV Series)
Pipe insulating material
B
(polyethylene foam, 6 mm thick)
C
Putty, PVC tapes
1110251267-EN.indd 2 1110251267-EN.indd 2
5
Filter
8
Flat head
4
Remote control holder
wood screw
Vinyl tape
Apply after carrying
out a drainage test.
Q'ty
One
each
1
One
each
Hook
1
Installation
plate
Insert the cushion between the indoor
unit and wall, and tilt the indoor unit for
better operation.
Do not allow the drain hose to get slack.
Shield pipe
Make sure to run the drain hose sloped
downward.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Saddle
Insulate the refrigerant pipes separately
with insulation, not together.
Extension
drain hose
(Not available,
provided by installer)
Fixing bolt arrangement of outdoor unit
• Secure the outdoor unit with fi xing bolts and nuts if the unit is likely to be
exposed to a strong wind.
• Use Ø8 mm or Ø10 mm anchor bolts and nuts.
108 mm
28 mm
Air outlet
600 mm
2
For the rear left and left piping
Wall
Cut the piping
hole sloped
slightly.
Right
Rear
right
Left
Bottom Rear
right left
Bottom left
6 mm thick heat resisting
polyethylene foam
125 mm
Air inlet
90 mm
Drain outlet
6/29/12 11:43 AM 6/29/12 11:43 AM