INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS
INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS
3
Batteries
2
Wireless remote control
Remark :
• Detail of accessory and installation parts can
see in the accessory sheet.
• Some pictures might be different from the
actual parts.
Optional Installation Parts
Part
Parts name
code
Refrigerant piping
Liquid side
: Ø6.35 mm
Gas side
: Ø9.52 mm
A
(RAS-10, 13G2KVP Series)
: Ø12.7 mm
(RAS-16G2KVP Series)
Pipe insulating material
B
(polyethylene foam, 6 mm thick)
C
Putty, PVC tapes
01_1115751102-EN.indd 3
01_1115751102-EN.indd 3
6
Flat head
4
Remote control holder
wood screw
Vinyl tape
Apply after carrying
out a drainage test.
• Secure the outdoor unit with fi xing bolts and nuts if the unit is likely to be
exposed to a strong wind.
Q'ty
• Use Ø8 mm or Ø10 mm anchor bolts and nuts.
• If it is necessary to drain the defrost water, attach drain nipple 7 and cap
water proof 8 to the bottom plate of the outdoor unit before installing it.
One
each
1
One
each
3
For the rear left and left piping
Hook
1
Installation
plate
Insert the cushion between the indoor
unit and wall, and tilt the indoor unit for
better operation.
Bush body
Do not allow the drain hose to get slack.
Shield pipe
Make sure to run the drain hose sloped
downward.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Right
Saddle
Insulate the refrigerant pipes separately
with insulation, not together.
Extension
drain hose
(Not available,
provided by installer)
Fixing bolt arrangement of outdoor unit
125 mm
29 mm
Air inlet
108 mm
Ø25 mm
Air outlet
600 mm
Drain outlet
Wall
Cut the piping
hole sloped
slightly.
Rear
right
Left
Bottom
Rear
right
left
Bottom left
6 mm thick heat resisting
polyethylene foam
* Drain nipple and
cap water proof are
packed in outdoor
unit.
99 mm
3/26/2557 BE 12:08 PM
3/26/2557 BE 12:08 PM
EN
EN
FR
IT
DE
PT
PL
CZ
RU
CR
HU
TR
NL
GR
SV
FI
NO
DK
RO
BG
EE
LV
SK
SI