Electronic Equipment; Safety Devices; Electronic Circuit Board - EdilKamin CALGARY Instalación Uso Y Mantenimiento

Ocultar thumbs Ver también para CALGARY:

Tabla de contenido

Idiomas disponibles

LEONARDO

is a combustion safety and control system which

allows optimal performance in all conditions thanks to two sen-

sors measuring the pressure level in the combustion chamber

and smoke temperature. The detection of and subsequent opti-

misation of these two parameters is continuous in order to cor-

rect operation anomalies in real time. The LEONARDO

offers constant combustion, automatically regulating the draft

based on the characteristics of the chimney ﬂ ue (bends, length,

shape, diameter, etc..) and environmental conditions (wind, hu-

midity, atmospheric pressure, installations at high altitude, etc.).

The standards for installation must be respected. LEONARDO

system is also able to recognise the type of pellets and automa-

tically djust the ﬂ ow moment by moment to ensure the required

level of combustion.

SAFETY DEVICES

THERMOCOUPLE:

Placed at the smoke outlet to detect the temperature.

Turns the boiler on and off and controls its operation based on

deﬁ ned parameters.

VACUUM GAUGE (electronic pressure sensor):

positioned on the smoke extractor, which detects the vacuum

value (compared to the installation environment) in the combu-

stion chamber.

WATER SAFETY THERMOSTAT:

Trips when the temperature inside the boiler is too high.

It stops pellet loading, causing the boiler-ﬁ replace to go out.

Reset manually (see pag. 26).

TANK SAFETY THERMOSTAT:

Located on the system that loads the pellets from the hopper.

Trips when the temperature inside the boiler-ﬁ replac is too high.

It stops pellet loading, causing the boiler-ﬁ replace to go out.

SERIAL PORT

The Dealer can install an optional on the AUX (located on the

electronic board), outlet for controlling the process of switching

on and off (e.g. telephone remote, local thermostat), located at

the rear oh the boiler.

Can be connected via special optional trestle (code 640560).

BACKUP BATTERY

A backup battery is found on the control board (3-Volt CR 2032

battery).

Its malfunction is indicated with the following messages: (not

considered a defect but due to normal wear-and-tear): "Battery

check". For more detailed information, please contact the DEA-

LER who has performed the ﬁ rst 1st ignition.