Changing The Bake Orifice, On Gas Ranges Only - Thermador PALPKITHW Manual De Instrucciones

4. Flip the hinge forward until seated on the bracket. A
screwdriver may be required to carefully push the clip
back.
5. Close and open the door slowly to ensure it is
correctly and securely in place.
Removing the kick and front panels
1. Remove the kick panel screws using a T-20 torx
screwdriver.
2. Remove the front panel screws using a T-20 torx
screwdriver.
Changing the bake orifice, on
GAS ranges only (PRG models)
Changing the main oven bake burner
orifice
IMPORTANT:
• Do not bend the bake burner tube.
• Do not bend the bake burner gas tube.
• The bake burner air shutter should remain fully open.
If the air shutter is not fully open, loosen the shutter
screw and adjust it to the position shown. Re-tighten
the screw to secure the shutter.
• Do not remove the anti-rotation bracket when
performing the orifice change. This bracket is critical
to the alignment of the bake burner tube with the
burner orifice. After the orifice replacement, this
bracket will facilitate the burner tube's realignment.
a c
b d
a. Anti-rotation bracket
c. Elbow fitting
e. Bake burner tube
mounting bracket
e f
b. Bake gas line
d. Shutter
f. Bake burner tube
Page. 17