Assembly And Operation - Worx WX175 Manual Original

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE (FOR WX175 WX175.1 WX175.2
WX175.9)
The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
INTENDED USE (FOR WX373 WX373.1 WX373.2
WX373.9)
The machine is intended for impact drilling in brick,
concrete and stone as well as for drilling in wood, metal
and plastic.

ASSEMBLY AND OPERATION

ACTION
BEFORE OPERATION
Checking the battery charge condition
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
CHUCK ADJUSTMENT
accessories. Always ensure the bit is secure before
starting the tool. Damage to the Chuck or a loose bit may
cause possible personal injury.
-- Removing the bits
-- Inserting the bits
Assembling the belt hook and bit clip
OPERATION
FORWARD/REVERSE ROTATION
CONTROL
FIGURE
chuck is rotating, wait until it has
stopped!
TWO-SPEED GEAR CONTROL
See Fig. A1
See Fig. A2
TORQUE ADJUSTMENT
SCREWDRIVING, DRILLING,
See Fig. A3
HAMMER DRILLING
See Fig. A4
OPERATING THE ON/OFF
SWITCH
because excess heat will be
produced internally.
WARNING: Always lock off trigger switch and
disconnect tool from power source when changing
WARNING: Never change the
direction of rotation when the
WARNING: Do not operate for
long periods at low speed
See Fig. B1
See Fig. B2
See Fig. C1, C2,
C3, C4
See Fig.D1,
15
D2, D3
See Fig. E
See Fig. F1,
F2, F3
See Fig. G