EDELRID FLEX PRO Manual De Instrucciones página 31

WARNING! The products must be kept away from
damaging environments. This includes contact with
abrasive and aggressive substances (e.g. acids
(battery acid!), alkalis, soldering water, oils, clean-
ing agents), as well as extreme temperatures and
flying sparks.
In addition, sharp edges, wetness and especially ic-
ing-up can diminish the stability of textiles.
CLIMATE REQUIREMENTS Fig. 12b
The permanent use temperature of the product (in
dry condition) ranges from approx. -20°C to +55°C.
LIFESPAN AND REPLACEMENT
The lifespan of the product mainly depends mainly
on the way and frequency in which it is used and
external influences.
Products made from synthetic fibre (polyamide, poly-
ester, dyneema) are subject to a certain ageing pro-
cess even if they are not used. This is caused by the
intensivity of UV-rays and environmental influences.
The maximum service life at optimum storage con-
ditions (see item Storage) and with no use is 12 years.
The maximum service life (commercial/non-com-
mercial use) assuming proper use, no visible signs of
wear, and at optimum storage conditions is 10 years.
PPE showing signs of wear must be replaced, for in-
stance, if the edges of webbing and straps are dam-
aged, if fibres have come off the webbing, if seams
are damaged or show signs of wear, or if the equip-
ment has come in contact with chemicals. Watch out
for sharp burrs or signs of corrosion on metal parts
of the equipment.
In case of extreme use (extreme signs of wear), for
instance, upon strain by a fall or when damage is vis-
ible, immediately remove the PPE from use and turn it
over to the manufacturer or a competent person for
inspection and/or repair; be sure to request a written
confirmation for the work done (Fig. 15).
Repairs may only be performed as outlined in the
instructions of the manufacturer.
INSPECTION
The product must be checked and, if necessary,
maintained whenever this is necessary but at least
yearly by the manufacturer, an expert or an autho-
rised testing centre.
In the process, it must be ensured among other
things that the product labelling is legible.
When the maximum service life of 10 years has been
reached, the PPE must be removed from further use.
STORAGE, TRANSPORT AND CARE
Storage
Store in a cool, dry, dark place outside transport
containers. Avoid contact with chemicals (caution:
battery acid!) Store without mechanical stress
caused by jamming, pressure or tension.
Transport
The product must be kept away from direct sunlight,
chemicals, dirt and mechanical damage. For this
purpose, a protective bag or special storage and
transport containers should be used.
Cleaning Fig. 12a and 13
Clean soiled products in luke-warm water (if neces-
sary, use pH-neutral soap). Rinse well. Dry at room
temperature, never use a tumble drier or dry close to
radiators! If required, halogen-free commercial disin-
fectants may be used.