Mounting Solenoid Box Over Drum - Prowinch PWLD Serie Manual Del Usuario

4.6 MOUNTING SOLENOID BOX OVER DRUM

1. Select the appropriate bracket hardware for your installation. Depending on your bumper, winch plate, or application, you will
need to determine which bracket choice to use.
2. Configure and attach brackets for mounting of Solenoid Box over drum.
3. Attach Solenoid Box to the tie bars over spool by hooking the Mounting Bracket around front tie bar and securing at the rear with
the 2 screws provided, making sure all cables are located between the solenoid box and the tie bar.
4. Make solenoid box to vehicle battery wiring after consulting wiring diagram.
Solenoid Box wiring
1. Connect short red cable (B) from Solenoid Box to red terminal (B) of motor.
2. Connect black cable with yellow jacket (C) to yellow terminal (C) of motor.
3. Connect short black cable with black jacket (D) to black terminal (D) of motor.
4. Connect thin black cable (E) to bottom terminal (A) of motor.
Winch Motor to Battery Connections
1. Ground motor by connecting long/thick black cable to bottom terminal (-) of motor and other terminal to Negative (-) post of
battery.
2. Power motor by connecting long/thick red cable (+) from control box to Positive terminal (+) of battery.
20
ATTENTION: Corrosion on electrical connections and battery terminals will reduce power and winch
performance. Keep battery charged, all connections clean and sealed with silicone-based sealer.
Fig. 7