Setting The Temperature; Filling The Water Reservoir - Fagor PL-2410 E Manual De Instrucciones

•
Do not direct the steam jet towards people.
• Do not use the iron on excessively wet
fabrics.
• Do not leave the iron supported on its base
while it is hot; leave it to cool down.
• Do not use stain-removing mixes or similar
products on fabrics to be ironed.
• The iron must be used and rested on a
stable surface
• When placing the iron on its stand, ensure
that the surface on which the stand is placed
is stable.
• The iron is not to be used if it has been
dropped, if there are visible signs of damage
or if it is leaking.
• Keep electrical appliances out of reach from
Children or infirm persons. Do not let them
use the appliances without supervision.
• The user must not leave the iron unattended
while it is connected to the supply.
• The plug of the supply cord must be
removed from the socket-outlet before the
water reservoir is filled with water
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety
• Children should be supervised to ensure that
they do not play with the appliance.

4. FILLING THE WATER RESERVOIR

• Place the unplugged iron on a stable
surface.
• Lift the water inlet cover. (8)
• Pour the water into the reservoir hole
using a glass (Fig. B).
• Do not put any cleaning products or
solvents into the water reservoir.
• Check that the water does not exceed
the maximum level and replace the
cover (8).
N.B.: If the water in the area where you live
o
is too hard (>27 F), we recommend that
you use distilled water. Do not use battery
water or water with added starch, perfume,
conditioner, etc.

5. SETTING THE TEMPERATURE

1. Place the iron on a stable surface and
plug it in. The LCD display (4) will light
up for a second, and a beep will sound
when it switches off.
2. Press the "increase temperature"
regulator to switch on the iron.
3. Change the temperature with the
screen settings: press the "increase
temperature" regulator (6) to raise
the temperature from 1 to 3 and
to Maximum. Press the "lower
temperature" setting (7) to lower the
temperature setting (Fig C).
4. To select the right temperature for each
item to be ironed, select the correct
point and the correct item, which will
appear on the LCD screen while you
move from one point to the next. Use
this table as a guide:
LCD SCREEN APPROX. TEMP. FABRIC
•
ACRYL
NYLON •
••
POLYE
••
BLEND
••
WOOL
•••
COTTO
LINEN MAX
5. The symbol will appear and
the "▲" symbol will flash when the
temperature changes from lower to
higher and the "▼" symbol will flash
when you change from higher to lower.
6. When the sole reaches the right
temperature, you will hear a beeping
sound and the "
on. The "▲" and "▼" symbols will
disappear.
7. The iron is ready for use.
12
Acrylic
70 - 90ºC
110 - 130ºC Nylon
115 - 135ºC
Polyester
Cotton and
145 - 165ºC
blends
Wool
160 - 180ºC
180 - 200ºC
Cotton
185 - 205ºC
Linen
" symbol will come