Stopping The Machine - Atlas Copco Pionjär Serie Instrucciones De Seguridad Y Para El Operario

Pionjär 120/120AV 130/130AV
3.
Pull the starting handle until the engine starts.
4.
Open the choke fully by turning it fully clockwise.
5.
After starting the engine let it warm up for 2–3
minutes before using the machine.
6.
© 2005 Atlas Copco Construction Tools AB
www.CrowderSupply.com • Toll Free: 888-883-5144
| |
No 9800 0438 51 2005-10-31
Safety and operating instructions
Regulate the fuel supply so that the engine runs
cleanly. During normal operation the fuel needle
should be opened by approx. 0.5 of a turn.
If the engine does not start, too much fuel may
have entered the combustion chamber. In this case
close the fuel needle by turning it clockwise and
start the engine with the choke open.
The engine speed can be regulated by means
of the throttle (figure 10). When the throttle is
released to the "up" position, the maximum engine
speed is obtained. Depressing the throttle halfway
down gives the engine idling speed. To stop the
engine, simply press the throttle to the bottom
position.
If the machine is frequently started on top of long
tools such as probing rods etc., a guide roller
must be used to avoid damaging the cord and
cord bushing. (Guide roller for Pionjär 120/120 AV,
130/130 AV: Order no. 9238 2803 81.)

Stopping the machine

1.
Press the throttle all the way down to the bottom
position.
2.
Close the fuel needle by turning it clockwise.
Note! Drain the fuel tank if the machine is to be
transported or stored for longer periods of
time.
13