Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
ASSEMBLY AND OPERATION
APPLICATIONS
Tightening and loosening of all types of bolts and nuts, used for securing structural
items.
REMOVAL AND INSTALLATION METHOD OF BATTERY
Handle
Rechargeable
battery
Fig. 3
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
Rechargeable
battery
d
Fig. 4
12
All manuals and user guides at all-guides.com
Latch
Insert
Pull out
1. Insert the plug of battery charger into
Battery installa-
tion hole
Pilot lamp
How to install the battery.
Align the battery with the groove in tool
handle and slip it into place.
Always insert it all the way until it locks in
place with a little click, If not, it may acciden-
tally fall out of the tool, causing injury to
you or someone around you. (Fig. 3)
How to remove the battery.
Withdraw battery from the tool handle while
pressing the latch on the side of the battery.
(Fig. 3)
the receptacle.
When the plug of battery charger has been
inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical
cord if damaged. Have
it repaired immediately.
Tabla de contenido
