Honda CB250 TWISTER Manual Del Propietário página 143

CB250 TWISTER
7. Remove the front axle shaft, front wheel and side
collars.
1. Left side collar
1
2. Front axle shaft
3. Axle pinch bolt
2
3
Installation
1. Attach the side collars to the wheel.
2. On the left side, place the wheel between the fork
legs and insert the front axle shaft to the end,
through the left fork leg and wheel hub.
3. Install and tighten the front axle nut.
Torque: 59 N·m (6.0 kgf·m, 44 lbf·ft).
4. Install the brake caliper and tighten the mounting
bolts.
Torque: 26 N·m (2.7 kgf·m, 19 lbf·ft).
Take care to prevent the brake caliper from
scratching the wheel during installation.
Use new mounting bolts when installing the
brake caliper.
NOTICE
When installing the brake calipers into position on
the fork legs, carefully fit the brake disc between
the pads to avoid scratching them.
5. Lower the front wheel on the ground.
6. Apply the brake lever several times. Then, pump
the fork several times.
7. Tighten the axle pinch bolt.
Torque: 22 N·m (2.2 kgf·m, 16 lbf·ft).
8. Raise the front wheel off the ground again, and
check that the wheel rotates freely after you release
the brake.
9. Uncover the protective tape or cloth.
If a torque wrench was not used for installation,
see your dealer as soon as possible to verify proper
assembly. Improper assembly may lead to loss of
braking capacity.
57