Wiring Connection; Wire - Toshiba MML-AP0074NH-E Manual De Instalación

Wiring connection

How to connect the power supply wiring and control wiring
REQUIREMENT
Connect the control wire after connecting the power supply wire for this model.
1) How to connect the power supply wiring
1. Removing the front panel.
2. Remove the terminal cover and cord clamp.
3. Take a power supply wire and control wire (according to the local rule) into the pipe hole on the hole.
4. Take the power supply wire out of the cable slot on the rear panel so that it produces about 430 mm form the front.
5. Insert the power supply wire fully into the terminal block and secure it tightly with screws.
Tighten torque: 1.2 N/m (0.12 kgf/m)
6. Clamp the power supply wire with the cord clamp.
7. Attach the terminal cover with a screw
• Be sure to refer to the wiring diagram attached inside the front panel.
• Check local electrical cords and also any specifi c wiring instructions and limitations.
• Do not catch the control wire when installing the clamp base.
Terminal cover (UP)
Power supply
terminal block
Terminal cover
Screw
<Stripping length of the
power supply wire>
CAUTION
Screw
Terminal block for control/wired
remote controller wiring
Screw
L N
Earth wire for
power supply

wire

Earth screw
Earth line
–19–
, ,
R(L) S(N)
Cord clamp
<Connecting power supply wire>
Installation Manual
EN
FR
DE
IT
ES
PT
NL
GR
RU
,
TR
CS
LV
SK
SI
Power supply
terminal block
Cord clamp
Power supply
wire
19-EN