Toshiba MML-AP0074NH-E Manual De Instalación página 22

2) How to connect the control wiring
1. Take the control wire out of the cable slot on the rear panel so that it produces about 600 mm form the front.
2. Remove the terminal cover (UP)
3. Remove the LED BASE
4. Insert the control wire fully into the control/Wired remote controller terminal block
tightly with screws.
5. Clamp the control wire with the cable clamp.
6. Pass the banding band through the hole of the mount base.
7. Band the control wire and the remote controller wire in the banding band.
8. Attach the LED base, terminal cover and front panel.
U1 U2
Control wire
LED base
Slot for fi x LED base
Hook for fi x LED base
<How to remove LED base>
20-EN
A B
Shield wire
Remote control wire
<Stripping length of the control wire>
Screw
Display base
Control wire
Shield wire for
earth wire
Earth screw for
shield wire
<Connecting control wire and remote controller>
–20–
Installation Manual
, , ,
Terminal block for control/wired
remote controller wiring
Remote controller wire
and secure it
Cable
clamp