Cutting A Hole And Mounting Installation Plate - Toshiba MML-AP0074NH-E Manual De Instalación

5
CUTTING A HOLE AND MOUNTING INSTALLATION
PLATE
Cutting a hole
(Rear piping)
100
(Bottom piping)
100
1. After determining the pipe hole position, drill the pipe
hole (∅65 mm) at a slight downward slant to the
outdoor side.
NOTE
• When drilling a wall that contains a metal lath, wire
lath or metal plate, be sure to use a pipe hole brim
ring sold separately.
Mounting the installation plate and
screw position
12-EN
(Side piping)
60
45
: Pipe hole (∅80 mm)
70
Floor
When installing the installation plate with a mounting
screw, do not use the anchor bolt hole.
Otherwise the unit may fall down and result in personal
injury and property damage.
NO OK
GOOD
∅5 mm hole
Clip anchor
(local parts)
Failure to fi rmly install the unit may result in personal
injury and property damage if the unit falls.
• In case of block, brick, concrete or similar type walls,
make ∅5 mm holes in the wall.
• Insert clip anchors for appropriate mounting screws.
NOTE
• Secure four corners and lower parts of the installation
plate with 6 mounting screws to install it.
(Unit : mm)
Wall
–12–
Installation Manual
CAUTION
NO
Anchor bolt
GOOD
Projection
15 mm or less
Mounting screw
s
4 mm x 25
CAUTION