Charging Process - Orbis VIARIS UNI Manual De Usuario

ENG

CHARGING PROCESS

VIARIS UNI chargers have the possibility to be configured so that when
required to activate the loading permit is done by tactile activation or by
activation with an RFID card.
When configured to activate through tactile activation, anyone can activate the
load.
When configured to activate using an RFID card, you must have the RFID card
associated. To activate RFID mode and associate cards see the Change
Procedure to RFID activation.
Start of the charge
1. Check that the charger is available (Rest Mode) and that the electric vehicle
does not have a charging time schedule.
2. Connect the electric vehicle to the smart charger.
3. Only in case of activation by RFID card.
It detects that a vehicle has been connected and remains awaiting activation
(connected mode without loading permission)
Bring the RFID card closer to the activation zone until you hear a
confirmation signal.
4. The charging of the electric vehicle will begin. (Load mode)
Please note that you will not be able to remove the charging plug from the
vehicle during the charging process, because it is blocked by a safety system.
Finish of the charge
Charging ends when the vehicle is fully loaded or because you want to interrupt
the charging manually (touch or RFID card).
In the event that the charge is completed when the vehicle is fully loaded, the
charger shall enter the End mode loading.
Tap again (touch activation) or pass the ID card (activation via RFID card) over
the activation zone until you hear a confirmation signal and pass to Connected
mode without loading permission.
To finish the load manually, tap slightly (touch activation) or pass the ID card
(activation via RFID card) through the activation zone until you hear a
confirmation signal and pass to Connected mode without loading permission.
84