Charging Process - Orbis VIARIS COMBI + Manual Del Usuario

CHARGING PROCESS

VIARIS COMBI + can be activated by touch or RFID

If configured for touch anyone can activate the charger.

If configured for RFID card – only the RFID card holder can activate the
charger.
These settings can only be configured via the e-VIARIS mobile app. (See
mobile app setting below).
Starting vehicle charge
By Touch:

Ensure charger is ON.

Connect the electric vehicle to the Smart Charger.

Start charge by touching activation zone.
By RFID:

Ensure charger is ON

Connect the electric vehicle to the Smart Charger.

Hold the RFID card close to the activation zone until you hear a
confirmation signal.

The charging of the electric vehicle will begin.
Charging by Time Schedule:

Ensure charger is ON.

Connect the electric vehicle to the Smart Charger.

Charging will begin at the programmed time.

To recharge your electric vehicle manually when there is a time
schedule, you must pass the RFID card twice.
NOTE: You will not be able to remove the charging cable from the vehicle
during the charging process as it is locked by a safety system.
Stopping Vehicle Charge
To stop the charge manually tap activation with touch or RFID until confirmation
signal is heard.
Fully Charged
Charging automatically ends when the vehicle is fully charged unless manually
stopped by touch or RFID card.
70