Orbis VIARIS UNI Manual De Usuario página 96

Charger connected to the vehicle and
time schedule but not load
The protections of the installation are
triggered
After manual deactivation or with RFID
card the load does not stop and the
outlet is blocked
The charger could not connect to a
WiFi network
Exceeding maximum power
View basic charger data, set up power
and scheduled
historical consumption, if I don't have
coverage in my garage floor
It takes a long time to load my vehicle
with a three-phase charger.
load, or consult
If the time scheduling indicator
fixed red, the vehicle does not support
external time programming. Schedule the
time interval on the vehicle itself, and
delete the charger schedule.
If the charge modulation indicator is off,
the TMC100 is not properly connected.
Check connection
direction of current and that the TMC100
is well closed, as indicated in the Load
Modulator section.
If the charge modulation indicator is
on, the adjusted power does not
match the contract.
Unlock the hose using the control of the
car.
If it was activated with a RFID card, check
that it is the same as the one used in the
activation, and check the list of authorized
cards.
If the WiFi indicator
not go to fixed target, it is because the
charger has not been correctly configured
or the correct password has not been
entered.
If the WiFi indicator is blinking blank, it's
because it's connected to an unconnected
WiFi network or the network security is
blocking it.
The modulator hasn't worked.
Check the configuration according to the
power contracted.
Read the section of the instruction manual
Smart charger control via web. (Once
connected to the Wi-Fi network with
password 12345678, we open a web
browser and write 192.168.4.1)
If you have purchased a single-phase
vehicle, you
approximately 1/3
power.
95
to the terminals,
is off and does
will only be using
of the contracted
ENG
is