Nice One OX4 Instrucciones Y Advertencias Para La Instalación Y El Uso página 8

5 – PROGRAMMING
EN
Warnings:
Some programming functions in this chapter use the key P1
and led L1 (fig. 3-G/H) of the receiver.
During programming the led emits a specific number of flash-
es, with a specific duration and colour (green, red or orange)
to indicate the current operating status. For the meaning of
these signals, consult Table B at the end of the manual.
Other functions can be programmed exclusively using the
devices Obox or Oview belonging to the NiceOpera system.
5.1 - MEMORISATION OF TRANSMITTERS
The receiver can memorise up to 1024 transmitters. Com-
patible with radio encoding "O-Code" / "FloR" / "TTS", or
"Smilo", or "Flo".
Caution! – these three encoding groups are not compatible
with one another; therefore the first transmitter memorised in
the transmitter also defines the encoding family for all the sub-
sequent transmitters.
To verify whether transmitters are already memorised on the
receiver and the relative encoding group, disconnect the
receiver from the power supply, switch on again and count the
number of green flashes, emitted by led L1:
1 flash = Flo encoding
2 flashes = O-Code / FloR / TTS encoding
3 flashes = Smilo encoding
5 flashes = no transmitter memorised
The transmitters can be memorised using one of the following
procedures:
• Procedure Mode I: programs all keys(*) of the transmitter
6
once only, associating each key to a relay, according to the
following scheme: key 1 = relay 1 / key 2 = relay 2 / key 3 =
relay 3 / key 4 = relay 4.
"Mode I" programs each key to operate in "hold-to-run" mode
on the respective relay.
(*) Note – If the transmitter has several codes, – such as the
models ON9, WM009C etc. with the keyboard divided into
groups of keys with each group associated with a specific
code, as if these were separate transmitters – the "Mode I"
procedure only memorises the keys belonging to a specific
group; the procedure must be repeated for each group.
• Procedure Mode II: programs a single key of the trans-
mitter associating it with the required function, from those pre-
sent in Table A.
Memorising a
transmitter in "Mode I"
01. Press and hold P1 on the receiver until the green Led L1
illuminates (after approx. 4 seconds) and then release;
02. Within 10 seconds, press and hold any transmitter key
to be memorised, until the green led L1 on the receiver
emits the first of 3 flashes to confirm memorisation.
When these flashes are completed, to memorise anoth-
er transmitter in "Mode I", press any key on the new
transmitter within 10 seconds.
Memorising a
transmitter in "Mode II"
01. In Table A select the function to be programmed (e.g.
"Function 8");
02. On the receiver, press P1 the same number of times