Advanced Programming - Nice One OX4 Instrucciones Y Advertencias Para La Instalación Y El Uso

01. Press and hold the receiver key
EN
02. After the green led illuminates, on the transmitter to be
deleted from the memory, press and hold a key (*) until
the led on the receiver emits 5 quick green flashes
(=deletion confirmed). Then release the two keys.
(*) Note – If the transmitter is memorised in "Mode I" press
any key; if the transmitter is memorised in "Mode II" the entire
procedure must be repeated for each memorised key to be
deleted.
This function can be performed also using the programming
unit Obox or Oview.
10
6 – ADVANCED PROGRAMMING
WARNING – Some settings described in this chap-
ter may only be possible if the receiver is combined
with other devices in the NiceOpera System; they also
require use of the programming unit Obox or Oview.
The receiver has other functions not described in this
manual that enable an increase in performance, secu-
rity level and ease of automation use. For further infor-
mation on the functions available, refer to the general
manual "NiceOpera System Book" or the instruction
manual of Obox or Oview.
• SETTING THE PASSWORD ON THE RECEIVER
[with Obox (OX4T ONLY) and Oview]
This function protects all programmed functions on the receiv-
er and also deactivates the key and led function. The function
is enabled by entering a password in the receiver, as selected
by the installer (maximum 10 digits).
When the function is active, the password must be entered
before programming or performing maintenance on the
receiver.
• ENABLING (or disabling) THE RECEIVER FOR
TRANSMITTER MEMORISATION
[with Obox (OX4T ONLY)]
This function is used to enable/disable the option on the
receiver for memorisation of a transmitter by means of the
procedure "in the vicinity of the receiver" (chapter 5, para-
graph 5.2) and/or by means of the "enable code" procedure
present on transmitters in the NiceOne series.
This function is useful to prevent events such as the accidental