Nice One OX4 Instrucciones Y Advertencias Para La Instalación Y El Uso página 14

• ENABLING (or disabling) THE "REPEATER"
EN
FUNCTION
[with Obox (OX4T ONLY)]
This function is used to enable/disable the option on the
receiver for repetition via radio of the command receiver, rout-
ing it to a second receiver. Using two receivers, one of which
with the "Repeater" function enabled, an automation can be
controlled from a greater distance to that normally covered by
a normal receiver-transmitter system.
This function is only available if receivers are associated with
transmitters using the "O-code" encoding system.
This function is disabled by default. To obtain this function,
it must be enabled on both the "repeater" receiver and the
required transmitters.
• ENABLING (or disabling) MANAGEMENT OF
TRANSMITTER KEY RELEASE
[with Obox (OX4T ONLY)]
This function is used to enable/disable the option on the
receiver synchronise the release of a key on a transmitter with
"O-Code" encoding and the response of an automation to
this action. Normally, when a command is sent, the manoeu-
vre is not stopped immediately on release of the key but after
a very brief interval (pre-set). Activation of this function enables
instant response of the automation on release of the key. This
function is disabled by default.
12
• ENABLING (or disabling) COMMAND DELIV-
ERY ON THE "T4 BUS" NETWORK
[with Oview]
This function is used to enable/disable the option on the
receiver for receiving and/or sending radio codes via the
BusT4 cable. On systems using this type of connection, if the
automation needs to be controlled at a distance greater than
that normally covered by the receiver-transmitter system, this
function can be enabled on receivers (at least 2) to increase
the radio transmission range; in this case the first receiver
receives the command "via radio" and re-transmits it via the
Bus cable to the destination receiver (which has memorised
the code of the transmitter that has sent the command). This
function is disabled by default.
• EXECUTING A COMMAND SENT FROM
TRANSMITTERS IN THE SAME FAMILY
[with Obox (OX4T ONLY)]
To program transmitters with Obox, each transmitter can be
inserted in one or more "families" (up to 4 groups).
When the receiver receives a command, it first checks to
which the transmitter it belongs; if its family is enabled at that
time, the receiver controls the outputs otherwise the com-
mand is blocked and indicated by means of an orange flash
of the led.
The family groups are formed using Obox, while use of the
groups is managed by other devices such as Oview. In par-
ticular, this can enable/disable operation of group of transmit-
ters within specific set time bands.