Tabla de contenido
Idiomas disponibles
Idiomas disponibles
This smoke alarm uses a 9V carbon backup battery (alkaline and lithium batteries
may also be used). A fresh battery should last for one year under normal operat-
ing conditions.
This alarm has a low/missing battery monitor circuit which will cause the alarm
to "chirp" approximately every 30-40 seconds for a minimum of seven (7) days
when the battery gets low. Replace the battery when this condition occurs.
USE ONLY THE FOLLOWING 9 VOLT BATTERIES FOR SMOKE ALARM
REPLACEMENT.
Carbon-zinc type
Alkaline type
Lithium type
NOTE: WEEKLY TESTING IS REQUIRED!
WARNING! BE SURE TO FOLLOW BATTERY INSTALLATION INSTRUCTIONS
PRINTED ON THE INSIDE OF THE BATTERY DOOR AND USE ONLY THE
BATTERIES SPECIFIED. USE OF DIFFERENT BATTERIES MAY HAVE A DETRI-
MENTAL EFFECT ON THE SMOKE ALARM.
CLEANING YOUR ALARM
YOUR ALARM SHOULD BE CLEANED AT LEAST ONCE A YEAR
To clean your alarm, remove it from the mounting bracket as outlined in the
beginning of this section. You can clean the interior of your alarm (sensing
chamber) by using compressed air or a vacuum cleaner hose and blowing or vac-
uuming through the openings around the temperature sensor located on the
top of the alarm. The outside of the alarm can be wiped with a damp cloth.
After cleaning, reinstall your alarm and test your alarm by using the test button.
If cleaning does not restore the alarm to normal operation the alarm should be
replaced.
After cleaning, reinstall your alarm. Test your alarm by using the test button and
check that the green LED is on.
EVEREADY 216 OR 1222; GOLD PEAK 1604P OR 1604S
ENERGIZER 522; DURACELL MN1604, MX1604; GOLD
PEAK 1604A; PANASONIC 6AM6, 6AM-6, 6AM-6PI,
6AM6X, and 6LR61(GA)
ULTRALIFE U9VL-J
Tabla de contenido
