Assembling The Cleaner; Hose Assembly - Pentair KREEPY KRAULY WARRIOR Instrucciones De Instalación Y Guía De Usuario

2

ASSEMBLING THE CLEANER

The Warrior™ Suction Side Pool Cleaner body is shipped
as one piece, making cleaner assembly a simple and
quick process.

Hose Assembly

For best results and to maintain proper operation, use
only original Pentair parts and hoses.
1. To connect the hose sections, wet the ends in the
pool water, then twist and push the female ends
onto the male ends.
Figure 2
Male Hose End
2. Connect the leader hose to the cleaner swivel.
See Figure 3.
Note: The leader hose is 12 inches (30.5
centimeters) in length and shorter than the other
sections included in the hose set. The leader
hose is also marked with a red sticker. Failure to
use this leader hose section will hinder cleaner
performance
3. The hose should reach from where the cleaner is
connected to the farthest point of the pool, plus one section and the leader hose.
4. Install the hose float onto the second length of
hose. The float should be placed 20 inches (50.8
centimeters) above the cleaner. See Figure 4.
5. Make sure that all connections are snug.
6. The overall length of hose needed will be
determined by the distance from the point at which
you attach the hose to the suction port to the
furthest point in the pool, plus one length and the
leader hose. Refer to Figure 5.
KREEPY KRAULY
WARRIOR™ Suction Side Pool Cleaner Installation and User's Guide
®
Female Hose End
Figure 3
Figure 4
Leader
Hose
Swivel
Assembly
20 in
(50.8 cm)
Figure 5