Stove Operation; Switching Off - Palazzetti ECOFIRE Manual De Instalación, Uso Y Mantenimiento

9 STOVE OPERATION

9.1 STARTING THE STOVE
To start the stove hold the * button for several
seconds.
The display shows the message "AWAITING
FLAME". This stage of operation is automatic and
managed completely by the stove itself. During this
stage the ame will be ignited and the stove will
reach steady operating conditions.
Subsequently, the display will show the message
"FLAME ON".
The stove will then automatically switch to the
"FIRE ON" stage when the temperature is suf cient
for correct operation (using the same operating
parameters as when the stove was last started).
Automatic stove ignition: the stove comes with an
automatic device that starts the pellet stove without
using other traditional re lighters.
Avoid lighting the ame manually if the stove's
automatic ignition system is not working correctly.
When the stove is started the first time,
disappear.
The room should be well ventilated when
9.2 MODIFYING THE PARAMETERS
The stove operating parameters, described in
paragraph 7.2, can be modi ed by the user in
three different ways based on the type of interface
selected (scrolling, compressed or easy).
SCROLLING MENU
With this interface con guration, the parameters are
shown cyclically on the display. When needing to
modify a value, wait for the desired parameter to be
displayed (Power, Fan, Set Room T.) and use the
button to increase the value or the
decrease it.
COMPRESSED MENU
When the stove is in the "FIRE ON" stage (shown
on the first row of the display), to modify the
parameters simply press the
the menu for modifying the parameters, Fig. 9.1.
The display will show the parameters (P, F, T) and
four symbols indicating the functions of the menu
buttons (OK, X, +, -).
To move from one parameter to the next press
("OK"). The selected parameter will ash, then to
modify the value press
Once all the parameters have been set, press
("X") to exit the menu.
To modify the parameters on the compressed menu
when not in the "FIRE ON" stage, rst access the
"OPERATING SETTINGS MENU" as illustrated in
paragraph 11.1.
54
USE AND MAINTENANCE
button to
button to access
("+") or ("-").
OFF
The values set will be retained until next
modi ed, even when the stove is switched
off or unplugged from the power supply.
EASY MENU
In this con guration you can only set the desired
room temperature using the up and down buttons.
Fan speed and power can not be changed. They
are automatically setted on "A".

9.3 SWITCHING OFF

To switch the stove off hold the
seconds. The display will show the message "FINAL
CLEANING" and the stove will activate, for a few
minutes, an automatic procedure to shut down in
complete safety.
To start the stove again it's recommended to wait
for the stove to cool down completely.
If attempting to start the stove again the display may
show the message "WAIT TO END CLEANING",
asking the user to wait until the stove has shut down
completely.
The stove should only be switched off following the
procedure described above. Never switch the stove
off by unplugging it from the power supply.
9.3.1
The purpose of this warning is to ensure that the
burn pot is clean before ignition and consequently
guarantee the best possible stove operation.
Never pour the contents of the burn pot into the
pellet hopper.
After having cleaned the burn pot reset the warning
by pressing and holding the
00 477 3370 - 09/2014 - PN - Italy
button for a few
OFF
button.
OFF
Fig. 9.1