Adjust The Pet Area To Desired Size; Test Light Instructions - Petsafe PIF-300-21 Manual De Adiestramiento Y Funcionamiento

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 72
STEP 3

Adjust the Pet Area to Desired Size

Make sure the entire Pet Area lies within your property boundaries (3A).
Always start determining the Boundary Zone at the shortest distance from
Transmitter. Place the Boundary Switch on "High" for Boundary Zones more
than 13.5 m (45 ft) from the Transmitter. For Boundary Zones below this
distance place the Boundary Switch on "Low."
Make sure the Receiver Collar battery is properly installed, the Static
Stimulation level is set at 2 or greater, and the Test Light Contacts are touching
the Contact Points (3B).
Note: If your next-door neighbor has an In-Ground containment system, see
Troubleshooting section page 20.

Test Light Instructions

1. Set the Stimulation Level to 2 or above.
2. Hold the Test Light Contacts to the Contact Points.
3. Walk toward the Boundary Zone holding the Receiver collar at your pet's
neck level until the Test Light fl ashes.
Save Test Light for future testing.
Note: If the Test Light does not fl ash, install a new battery and re-test. If Test Light still does not fl ash,
contact the Customer Care Centre or visit our website at www.petsafe.net.
To maximize your Pet Area, make sure the Boundary Switch is on "High" and the Boundary Control
Dial is set to "8". Plug Power Adapter into Power Jack and standard outlet.
Two-Person Method
Hold the Receiver Collar at your pet's neck height (3C) with the Petsafe logo facing away from
the Transmitter. Walk to the edge of the desired Pet Area. Facing away from the Transmitter, hold the
Receiver Collar at the edge of the desired Pet Area (3D).
Starting with the Boundary Control Dial set to "8", have a second person turn the dial down
SLOWLY. When the Receiver Collar starts to beep, tell the person to stop turning the Boundary
Control Dial. Record your settings below for future reference.
One-Person Method
Measure the shortest distance from the desired
Boundary Zone to the Transmitter. Find the distance on
the Transmitter Range Chart on page 11 and set the
Boundary Switch and Boundary Control Dial. Hold the
Test Light Contacts to the Contact Points (3B). Take the
Receiver Collar to the Boundary Zone with the logo side
facing away from the Transmitter and Contact Points
facing upwards (3C). Hold the Receiver Collar at your
pet's neck level (3D) until the Receiver Collar beeps and
the Test Light fl ashes. If the Receiver Collar beeps before or after the desired Boundary Zone, return
to the Transmitter and adjust the Boundary Control Dial. Repeat this process until the Receiver Collar
is beeping at the desired location. Record your settings on page 11 for future reference.
10
www.petsafe.net
3A
Pet
Area
3B
3C
Boundary
Zone
3D
Pet
Area
Tabla de contenido

Solución de problemas

loading

Tabla de contenido