To Re-Thread The Collar - Petsafe PIG20 Manual De Funcionamiento

To assure a proper fi t, please follow these steps:
1.Turn the Receiver Collar battery to the OFF position.
2.Have your pet standing comfortably (9A).
3.Place the Receiver Collar on your pet so that the battery module is pointing down. Centre the Contact
Points underneath your pet's neck, touching the skin (9B).
You may need to trim the hair in the area of the
Contact Probes. Never shave the dog's neck; this
may lead to a rash or infection.
4. The Receiver Collar should fit snugly, yet loose enough to allow one finger to fit
between a Contact Point and your pet's neck (9B). Allow your pet to wear the collar
for several minutes, then recheck the fit. Check the fit again as your pet becomes more
comfortable with the Receiver Collar.
5. Once you are satisfied with the fit of the Receiver Collar then you may trim any excess
collar strap as follows (9C):
a. Mark the desired length of the Receiver Collar with a pen. Allow for growth if your pet
is young or grows a thick winter coat.
b. Remove the Receiver Collar from your pet and cut off the excess.
c. Before placing the Receiver Collar back onto your pet, seal the edge of the cut
collar by applying a flame along the frayed edge.

To Re-Thread the Collar

Slide Buckle
Ridges
The slide buckle prevents the collar from
becoming loose around your pet's neck.
The ridges must be facing up; the collar will slip if
it is not properly threaded.
www.petsafe.net
9A
9B
9C
17