Connecting The Pressure Washer To Another Water; Source - Stihl RE 90 Manual De Instrucciones

8 Connecting to a water source
► Turn off water tap.
► To release the coupling: Pull or turn ring (1) and hold.
► Pull the coupling off the connector (2).
8.3 Connecting the pressure washer to another
water source
The pressure washer can draw water from water butts and
cisterns and from running or stagnant bodies of water.
So that the water can be drawn in, the height difference
between the pressure washer and the water source should
not exceed the maximum suction lift (a), @ 19.1.
The appropriate STIHL suction set must be used. The
suction set includes a water hose with a special coupling.
Depending on the market, the appropriate STIHL suction set
may be supplied with the pressure washer.
Connecting the water filter
If operating the pressure washer with sandy water from
water butts, cisterns or running or stagnant bodies of water,
a water filter must be connected in-line between the water
hose and the pressure washer.
Depending on the market, the water filter may be supplied
with the pressure washer.
0458-814-8721-A
A
2
► Unscrew connector (1).
► Screw water filter (2) onto connector (3) and tighten hand-
tight.
Connecting the water hose
1
4
► Fill water hose (1) with water until there is no air left in the
water hose.
► Screw coupling (2) onto connector (3) of water filter and
tighten hand-tight.
► Suspend the suction cup (4) in the water source so that
the suction cup (4) does not touch the bottom.
► If the spray gun is attached to the high-pressure hose:
remove the spray gun.
► Hold the high-pressure hose downward.
► Switch on pressure washer and run it until an even jet of
water is delivered by the high-pressure hose.
► Switch off pressure washer.
English
3
1
2
1
3
55