Removing And Inserting The Grinding Table (Fig.3); Affixing And Replacing Grinding Wheels (Fig. 4); Adjusting The Grinding Table Angle (Fig. 5) - Proxxon TG 125/E Instrucciones De Uso

horizontal position or standing vertically (for
sharpening tools and blades for example).
In both positions, the machine should be
securely clamped with the enclosed vice, as
shown in fig. 2.
5.2 Removing and inserting the grinding
table (fig.3):
Caution:
Before removing and inserting the grinding table,
always disconnect the mains plug to prevent the
disc being started up accidentally. Risk of injury!
Normally, your TG 125/E is operated with the
attached grinding table (as in delivery
condition). Additionally, there is also the
possibility, where required, of removing the
grinding table, if this is necessary for certain
tasks or for changing the grinding wheels.
1. Remove Allen head screw 1
2. Remove the grinding table with grinding
table holder 2 by pulling out from the front
3. To insert, simply push into the normal
position
4. Turn in Allen head screw 1 again
5.3 Affixing and replacing grinding
wheels (fig. 4):
Note:
Before affixing or replacing the grinding wheels,
always disconnect the mains plug to prevent the
disc being started up accidentally. Risk of injury!
Two grinding wheels in each of the grain sizes
80, 150 and 240 are supplied as initial
equipment with your disc grinding machine;
these can also be easily obtained as spare
parts. It is therefore no problem to change
wheels, whether because of wear or because
discs with various grain sizes are required when
working.
Caution:
When replacing the wheels, it is advisable to
remove the grinding table as described in the
previous section!
1. Remove the rear protective foil above the
adhesive surface from the desired wheel,
2. Push the wheel evenly and bubble-free onto
the grinding disc.
3. To replace, simply remove the grinding wheel
again and push on the new wheel.
Caution:
There are also two storage discs made of silicon
foil included in the scope of delivery. If a
grinding wheel is to be used again after
removal, please cover the adhesive surface with
foil for storage!
5.4 Adjusting the grinding table angle
(fig. 5):
Caution:
Before adjusting the grinding table, always dis-
connect the mains plug to prevent the disc
being started up accidentally. Risk of injury!
1. Loosen rotary knob 1 At the same hold rotary
knob 2
2. Swing grinding table 3 into the desired angle
position and check the set value on angle
scale 4.
3. Tighten rotary knob 1. At the same hold
rotary knob 2
- 13 -