Stihl FS 85 Manual De Instrucciones página 69

8
Place the secured assembly on the
N
handle support (8) with the wing
screw at the side nearest the
engine.
Push the wing screw into the handle
N
support as far as stop and then
screw it down – but do not finally
tighten yet.
Line up the handlebar at a right
N
angle to the drive tube – check
distance A again.
Tighten down the wing screw firmly.
N
FS 85, FS 85 R
Mounting the Control Handle
Take out the screw (9) – the nut (10)
N
remains in the control handle (11).
Push the control handle onto the
N
handlebar (7) until the holes (13)
line up – the throttle trigger (12)
must point towards the gearbox.
Insert the screw (9) and tighten it
N
down firmly.
Fitting the Throttle Cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
15 14
15
15
Position the throttle cable
N
retainer (15) and throttle cable (14)
against the drive tube.
Close the throttle cable
N
retainer (15). The retainer (15)
snaps into place.
Adjusting the Throttle Cable
Check adjustment of throttle cable –
N
see chapter on "Adjusting the
Throttle Cable".
English
14
67