Transport-Unloading; Installation; Electrical Connection To Mains; Connecting The Equipment Components - Selco Genesis Serie Instrucciones De Uso

3 TRANSPORT - UNLOADING
Never underestimate the weight of the equipment,
(see technical specifications).
Never make the cargo pass or leave it suspended
over people or things.
Neither let the equipment or the single unit fall,
nor put it down with force.
Once it has been removed from the packing, the
power source is supplied with an extendible belt
which can be used to move it in the hand or on the
shoulder.

4 INSTALLATION

Choose an adequate installation area by following
the criteria provided in Section "1.0 WARNING".
Do not position the power source and the equip-
ment on surfaces with inclination exceeding 10°
with respect to the horizontal plane.
Protect the installation from heavy rain and sun.
Do not use the power source to thaw pipes.

4.1 Electrical connection to mains

The system is provided with one single electrical connection
with 5 m cable at the rear of the power source.
Power source input cable and fuse sizing table:
Power source G. 282 PME
Rated voltage
Voltage range 340V ÷460V (400V +15% -15%)
Delayed fuses 20A
Power supply cable 4x6mm2
WARNING
* The electrical system must be made by skilled technicians
with the specific professional and technical qualifications
and in compliance with the regulations in force in the
country where the equipment is installed.
* The welding power source supply cable is provided with a
yellow/green wire that must ALWAYS be earthed. This yel-
low/green wire must NEVER be used with other voltage
conductors.
* Verity the existence of the earthing in the used plant and
the good condition of the socket/s
* lnstall only plugs that are homologated according to
the safety regulations.
G. 352 PME G. 503 PME
400 V3~
30A 40A
4x6mm2 4x6mm2

4.2 Connecting the equipment components

Disconnect the generator plug from the mains
socket before making the connections.
Keep to the safety regulations contalned in section
"1.0 WARNING".
Connect the componente carefully, in order to
avoid power losses.

5 ASSEMBLING THE EQUIPMENT

5.0.1 Assembling the movable trolley

For the assembly of the generator trolley GT23, see SPARE
PARTS TABLES.

5.1 Connecting the unit

5.1.1 Connection for MMA welding

Carefully read 4.2.
* Connect the earth clamp
to the negative socket (-)
of the generator.
* Connect the electrode
holder to the positive
socket (+) of the genera-
tor.
The connection described above ensures welding
with reverse polarity. To weld with straight polarity,
reverse the connection.

5.1.2 Connection for TIG welding

Carefully read 4.2.
1) Connect the earth clamp
(Fig. 6) to the positive
socket (+) of the genera-
tor.
2) Connect the TIG torch
coupling to the negative
socket (-) of the genera-
tor.
3) Connect the gas fitting to
the pressure reducer.
Fig. 5
Fig. 6
19