Start The Pump - AquaPRO 63043 Manual Del Propietário

Electrical
WARNING: It is recommended all electrical work be performed
by a licensed electrician.
WARNING: Before wiring the pressure switch, turn off the power
source to which you are connecting to avoid potentially life
threatening electrical shock.
WARNING: When wiring from the power source to the pressure
switch, it is recommended that you use either a 14-gauge or
12-gauge cord.To complete the installation, you must connect
the power source to the pressure switch. A 30/50 psi pressure
switch has been installed on the pump. The pressure switch allows for automatic operation; the pump starts when pressure
drops to the "cut-in" setting (30 psi pre-set).
To wire the pressure switch:
 Remove the pressure switch cover on the pump to expose the wiring terminals.
Connect the green ground wire of the power supply to the switch ground terminal.

Connect the power supply wires to the two outside terminals marked "LINE" and replace the switch cover.

CAUTION: Do NOT use a pressure switch set at a pressure greater than 50 psi. The pump will not create pressures
greater than 50 psi, if so the pump will never shut off, resulting in damage to the pump and voiding the warranty.
Voltage Setting
This pump is pre-wired at 230 volts.

If the power source is 115 volts, remove the electrical housing

cover.
 Flip the switch to 115 volts. Replace the cover.
NOTE: All electrical work should be performed by a licensed
electrician.

Start the Pump

1. Power on! Start the pump. The pump should pump water in two or three minutes.
2. If you don't have water after 2 or 3 minutes, stop the pump and remove the fill plugs. Refill the pump and piping. You may
have to repeat this two or three times in order to get all the trapped air out of the piping.
The control valve remains open throughout this procedure.
3. After the pump has built up pressure in the system and shut off, check the pressure switch operation by opening a faucet
or two and running enough water out to bleed off pressure until the pump starts. The pump should start when pressure drops
to 30 PSI and stop when pressure reaches 50 PSI. Run the pump through one or two complete cycles to verify correct
operation. This will also help clean the system of dirt and scale dislodged during installation.
Congratulations on a successful installation.
If you were unsuccessful, please refer to Troubleshooting or call our customer service technical staff.
9