Package Contents; Location Of The Pump - AquaPRO 63043 Manual Del Propietário

Ocultar thumbs Ver también para 63043:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

PACKAGE CONTENTS

Part
A
B
C
D
E
F
G
PRE-INSTALLATION
Determine the depth of your well
Tie a small but heavy weight such as a fishing weight to the end of a piece of cotton string. Lower the weight into the well until
it reaches the bottom of the well. Make a mark on the string at ground level. Pull the weight out of the well and measure from
the bottom of the weight to the ground level mark. This is the depth of your well. Subtract five feet from the depth of your well.
If this number is less than 25 feet, shallow well installation should be taken. If this number is more than 25 feet and less than
70 feet, deep well installation should be taken. If this number is more than 70 feet, a deep well submersible pump should be
selected. Measure the ground level mark to the mark where the cotton string is wetted. This number is your well's water level.
Lower the pipe into the well until the strainer is five feet above the bottom of the well. It should also be at least 10 feet below
the well's water level while the pump is running in order to prevent the pump from sucking air due to water level drawdown.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and
hardware contents above. If any part is missing or damaged, do not attempt to assemble the product. Contact customer
service for replacement parts.

LOCATION OF THE PUMP

Decide on the area for the pump installation. Select a pump location with adequate space for future pump maintenance. It
can be located in the basement or utility room of the house, at the well, or between the house and the well. If installed outside
of the house, it should be protected by a pump house with auxiliary heat to prevent possible freezing. Protect the pump
Description
Quantity
Pump
Tank
Discharge tee
Stainless steel
braided hose
Rubber Washer
Venturi tube (#11)
Nozzle (#01)
Part
Description
1
H
Pressure regulator
1
I
Pressure tube
1
J
Pressure gauge
1
K
Flat washer
1
L
Bolt
1
M
Spring washer
1
N
Nut
4
Quantity
1
1
1
4
2
2
2
Tabla de contenido
loading

Tabla de contenido