Feeding-In The Wire En - Abicor Binzel iROB Feed 22/MP Instructivo De Servicio

6 Putting into operation
6.5 Feeding-in the wire
1
12
11
1 2 pressure levers
2 Cover
3 2 pressure rockers
4 Clamping nut
Fig. 10
Feeding in the wire
Risk of crushing
Limbs can be drawn in and crushed.
• Do not reach into moving wheels.
• During operation, close the housing cover.
NOTICE
• Make sure that the cable assembly is as straight as possible in order to allow a short and rectilinear
1 Open the cover (2) and allow it to lock into place.
2 Swing open the pressure lever (1) and open the pressure rockers (3).
3 Screw the inlet tube (12) on the wire conduit / master liner (11), slide it into the motor plate (10) and
fix it by means of the screw (9).
4 Loosen the wire (7) from the basket spool or from the drum and feed it into the wire
conduit / master liner (11).
5 Insert the wire (7) through the inlet tube (12) over the driving rollers (6) into the torch connection (5).
6 Close pressure rockers (3) and fold pressure lever (1) back.
NOTICE
• Set the contact pressure in a way that the wire (7) is not damaged and runs smoothly.
7 Set the contact pressure by means of the clamping nuts (4).
EN - 18
10 9
5 Torch connection
6 Driving rollers
7 Wire
WARNING
wire feed.
2
8 7
8 Inching trigger
9 Screw
10 Motor plate
iROB Feed
3
4
5
6
11 Wire conduit/master liner
12 Inlet tube
BAL.0331.0 • 2019-03-11