Dismounting; Disposal - Abicor Binzel iROB Feed 22/MP Instructivo De Servicio

iROB Feed

11 Dismounting

Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance, servicing, mounting,
dismounting and repair work:
• Switch off the power source.
• Close the gas supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
NOTICE
• Dismounting may only be carried out by qualified personnel (in Germany see TRBS 1203).
• Please observe the operating instructions of the welding components, such as the robot welding
• Observe the information provided in the following chapter:
1 Remove the intermediate cable assembly and the cable assembly of the welding torch from the wire
feeder.
2 Remove parts to be disconnected.

12 Disposal

When disposing of the system, local regulations, laws, provisions, standards and guidelines must be
observed. Observe the regulations on the disposal of electronic scrap and dispose of it at your local waste
disposal site (e.g. recycling centre).
To correctly dispose of the product, it must first be disassembled. Please take note of the following
information:
 11 Dismounting on page EN-27
12.1 Materials
This product is mainly made of metallic materials which can be melted in steel and iron works and are, thus,
almost infinitely recyclable. The plastic materials used are marked in preparation for sorting and separation
of the materials for later recycling.
12.2 Consumables
Oil, greases and cleaning agents must not contaminate the ground or enter sewage systems. These materials
must be stored, transported and disposed of in suitable containers. Observe the relevant local regulations
and disposal instructions of the safety data sheets specified by the manufacturer of the consumables.
Contaminated cleaning tools (brushes, rags, etc.) must also be disposed of in accordance with the
information provided by the manufacturer of the consumables.
12.3 Packaging
ABICOR BINZEL has reduced the packaging for shipping to a minimum. Packaging materials are always
selected with regard to their possible recycling ability.
BAL.0331.0 • 2019-03-11
DANGER
, cooling unit
power source iROB Pulse
 8 Putting out of operation on page EN-21.
iROB Cool and welding torch.
11 Dismounting
EN - 27