Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Mixing a Drink
wWARNING
Electrical Shock Hazard
Plug into a grounded outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
1. Place the ingredients to be mixed into an appropriate
container. See "Mixing Containers" section.
2. Set the speed control for the desired mixing speed.
NOTE: You will have to develop a speed and time
required to obtain desired results with various mixes.
3. Push the START-STOP button to turn ON.
NOTE: The agitator MUST always be on before
it comes in contact with the ingredients.
4. Slowly insert the container up into the mixer until
the agitator comes in contact with the ingredients.
Move the container up and down for thorough
mixing. The splash shield will move up and down
when it comes in contact with your hand or wrist.
5. When the mixing is complete, slowly lower and
remove the container from the mixer and push
the START-STOP buttton to turn off.
Using the Timer Knob (on 120V Model)
1. The Timer Knob allows the operator to set a mix time
in 5-second increments between 5 and 40 seconds.
2. When the START-STOP button is pushed, the unit
will mix for the preset amount of time, then beep
3 seconds before the end of the cycle.
3. The FP (Foot Pedal) setting allows operator to run
the mixer by a foot pedal control. The Foot Pedal
controls the amount of time the mixer runs.
4. The infinity
setting allows the mixer to run
continuously until turned off. NOTE: The mixer
will turn off automatically after 180 seconds.
wWARNING
Cut Hazard
Always use collar when operating with
paper cup.
Always use shield when mixing.
Do not put spoon or other utensils
in cup when mixing.
Failure to follow these instructions can
result in broken bones or cuts.
NOTE: Agitator is subject to wear and tear during
normal usage. Inspect agitator daily. Replace
agitator every 90 days.
Using the Timer Knob (on 230V Model)
1. The Timer Knob allows the operator to set a mix time
in 5-second increments between 5 and 40 seconds.
2. When the START-STOP button is pushed, the unit
will mix for the preset amount of time, then beep
3 seconds before the end of the cycle.
3. The infinity
setting allows the mixer to run
continuously until turned off. NOTE: The mixer
will turn off automatically after 180 seconds.
Operating the Mixer
Use collar with paper cup
5
Tabla de contenido
