HERKULES DS 405/1 E Manual De Instrucciones página 12

Anleitung DS 405-1 E 21.07.2004
GB
CARELESSNESS TO RESULT IN SERIOUS
INJURIES.
Wear goggles
Wear ear-muffs
Wear a breathing mask
Noise emission values
The saw's noise is measured in accordance with
DIN EN ISO 3744; 11/95, DIN EN 11201. The
machine may exceed 85 dB(A) at the workplace.
In this case, noise protection measures need to
be introduced for the user (ear-muffs).
Cutting
Sound pressure level LPA 74,5 dB(A) 62,7 dB(A)
Sound power level LWA 87,6 dB(A) 75,7 dB(A) „The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immission
level at the workplace include the duration of impact,
the type of room, and other sources of noise etc.,
e.g. the number of machines and other neighbouring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved."
5. Technical data
Asynchronous motor 230 V
Power rating
Operating mode
Idle speed n0 400-1600 rpm
Protection type
Stroke
Tilting table 0° to +45° to the left
Table dimensions 410 x 253 mm
Blade length
12
14:55 Uhr Seite 12
Throat depth
Cutting height max. at 90°
Cutting height max. at 45°
Weight
6. Before putting the machine into
operation
All covers and safety devices have to be properly
fitted before the machine is switched on.
It must be possible for the blade to run freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
machine's moving parts run smoothly.
Before you connect the machine to the power
supply, make sure the data on the rating plate is
Idling the same as that for your mains.
6.2 Mounting the saw on a workbench Fig. 2
1. It is better to mount the saw on a solid wood
workbench rather than on a weak plywood stand
2
Saw body
Foam rubber mat
Work table
Gasket
Washer
50 Hz
Hex nut
120 W
Lock nut
Hex screw
S2 5min.
where vibrations and noise are certain to be a
IP 40
nuisance.
21 mm
2. The tools and hardware needed to mount the
saw on a work bench are not supplied with the
saw. Be sure to use equipment of at least the
following size:
127 mm
406 mm
57 mm
27 mm
12 kg