JVC UX-H35 Serie Manual De Instrucciones página 29

Troubleshooting
If you are having a problem with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified
person, such as your dealer, for service.
Symptom
No sound is heard.
Hard to listen to broadcasts because
of noise.
The disc does not play.
The disc sound is discontinuous.
The cassette holder cannot be
opened.
Impossible to record.
Operations are disabled.
Unable to operate the unit from the
remote control.
Specifications
Amplifier
Output Power:
20 W (10 W + 10 W) at 4 Ω (10% THD)
Audio input sensitivity/Impedance (at 1 kHz)
AUX:
Speakers/Impedance:
Tuner
FM tuning range: 87.50 MHz – 108.00 MHz
AM tuning range:
AM 10 kHz intervals: 530 kHz – 1 710 kHz
AM 9 kHz intervals: 531 kHz – 1 710 kHz
CD player
Dynamic range:
Signal-to-noise ratio:
Wow and flutter:
Cassette deck
Frequency response:
Normal (type I):
Wow and flutter:
Cause
• Connections are incorrect or
loose.
• Headphones are connected.
• Antennas are disconnected.
• The AM loop antenna is too close
to the unit.
• The FM antenna is not properly
extended and positioned.
The disc is placed upside down.
The disc is scratched or dirty.
Power from the power cord has been
cut off while the tape was running.
Small tabs on the back of the
cassette are removed.
The built-in microprocessor may
malfunction due to external
electrical interference.
• The path between the remote
control and the remote sensor on
the unit is blocked.
• The batteries are exhausted.
500 mV/48.75 kΩ
4 Ω
85 dB
90 dB
Immeasurable
50 Hz – 15 000 Hz
0.15% (WRMS)
• Check all connections and make
corrections. (See pages 6 – 9.)
• Disconnect the headphones.
• Reconnect the antennas correctly
and securely.
• Change the position and direction
of the AM loop antenna.
• Extend the FM antenna to the best
position.
Place the disc with the label side up.
Clean or replace the disc. (See page
23.)
Plug in the power cord, then turn on
the unit.
Cover the holes with adhesive tape.
Unplug the power cord and then
plug it back in.
• Remove the obstruction.
• Replace the batteries.
Design and specifications are subject to change
without notice.
Speaker
Speaker units:
Full range:
Impedance:
Dimensions (approx.):
135 mm x 203 mm x 190 mm (W/H/D)
Mass (approx.):
Supplied Accessories
See page 6.
General
Power requirement:
AC IN: 110 V/ 127 V/ 230 V
adjustable with the voltage
selector, 50 Hz/ 60 Hz
DC IN: 12 V, 4 A
Power consumption:
Dimensions (approx.):
412 mm x 208 mm x 275 mm (W/H/D)
Mass (approx.):
Action
8.0 cm cone x 1
4 Ω
1.7 kg each
,
35 W (at operation)
3.0 W (on standby)
6.5 kg
24