Oven electrical connection
Ensure the electric current has been disconnected before
connecting the oven to the electric mains.
ATTENTION
If the flexible cable is not intact, to avoid any risk, it must
be completely replaced with a cable having the same
characteristics and only by qualified staff.
The oven requires single-phase alternate current 220-230-240
V~ 50-60 Hz, using flexible cable. Ensure the household power
supply can support the electric load of the device. (see serial
plate). The electric safety of this appliance is only assured if the
same is correctly connected to a system having efficient earth
connection, according to the legal standards in force.
Assembly/replacement of the power supply cable
If the power supply cable is damaged, it must be replaced
by the manufacturer, its after-sales assistance or by other
qualified staff in order to prevent all possible risks.
The electric cable must be kept secured to the terminal block
by means of a cable fix so that it cannot come out. Connect the
line cable to terminal L, the neutral cable to terminal N and the
yellow/green cable to the earth terminal
cable must be longer than the other two by at least 20 mm.
Ensure the electric cable does not pass near or come into
contact with the surfaces reaching a temperature above 75°C.
INSTALLATION, USE AND MAINTENANCE INSTRUCTIONS
In case of direct connection to the mains (without the use of
the plug) include a device that ensures disconnection from
the network, with a distance enabling full disconnection in the
conditions of overvoltage category III, in accordance with the
relevant installation regulations.
In models where present, the flexible cable is supplied without
plug. The plug to be used must be suitable for the electric load
of the product and must comply with the current regulations.
The installer must ensure that the socket is suitable for the
power absorbed by the oven as indicated on the serial plate.
The connection socket must be easily accessible. Disconnection
of the appliance from the electrical supply must also be possible
after the completion of installation.
The yellow/green
BUILT-IN ELECTRIC OVENS
EN
31