Oven User Guide - Smalvic FI-74MT Manual De Instrucciones

Hornos eléctricos para empotrar
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

USER GUIDE FOR OVEN
Commissioning
Disconnect the appliance from the mains electricity and remove
the accessories from the appliance. Clean them thoroughly
with warm water and detergent and put them back in the initial
position. Before using it for the first time, allow it to run on empty
and at maximum for about 2 hours while ventilating the room
well. The combustion fumes of the production residues will be
evacuated. Ventilate the environment well during heating.
Power indicator LED
When on, it indicates that the oven is live and on.
Oven operating LED
The LED on indicates the heating phase; the LED odd indicates
that the temperature set has been reached.
Flashing indicates that the temperature is maintained constant
on the value set.
Oven temperature thermostat
Turning the relative knob clockwise, it controls the temperature
inside the oven at the desired value between 50° and 270°C
Programs switch or selector
The switch activates the type of functioning desired for cooking.
(varies according to models)
Mechanical timer CM
The timer allows an acoustic signal after a pre-established time,
independently from cooking.
8
PSC mechanical cooking end programmer
Allows programming interruption of cooking for a certain amount
of time (maximum 2 hours).
Programmed functioning:turn the knob clockwise and select
the desired cooking time. When time is up, the oven will
automatically turn off and an acoustic signal will mark the end
of cooking.
Manual functioning: to use the oven in a traditional manner
without any programming, turn the knob anti-clockwise to the
symbol
.
Analogue cooking end programming clock
Allows a cooking end to be programmed (maximum 3 hours) in
the same mode as the PSC by turning the small knob
always clockwise.
Adjusting the time: pull the knob lightly and turn it clockwise
until the clock is set at the current time.
Manual operation: Turn the knob clockwise until the hand
reaches the manual symbol.
ATTENTION
The oven cannot work if the programmer is at O

Capítulos

Tabla de contenido
loading

Tabla de contenido