Cleaning The Steam Valve - Fagor CAT 40 NG Instrucciones De Uso

The receptacle must have a capacity of
300 ml.
Open the hot water nozzle.
The indicator e "Steam preselection"
goes off. The program executes a fresh
water rinsing operation over the hot
water nozzle. The pump stops automati-
cally after the rinsing operation is over,
indicator "Steam preselection" starts to
flash.
Shut the steam valve. The indicator e
"Steam preselection" goes off.
The program executes a fresh water
rinsing operation over the brewing
unit.
The pump stops automatically after
the rinsing operation is over, indicator
27 Empty coffee grounds container"
flashes.
Empty and clean the coffee grounds
container. Put the coffee grounds
container back into the unit, the
indicator h "Empty coffee grounds
container" goes off.
Pull out the drip tray, rinse it
thoroughly and re-insert it. Pull out the
water reservoir, fill it up with fresh
water and insert it again.
The appliance is now ready for
operation again.
In case of power failure during the
descaling process the program has to
be started again! The appliance is now
ready for operation again and the
status is that of the last coffee mode
selected.
We recommend pouring away the first
cup of coffee made after running the
descaling programme.

15.8 Cleaning the steam valve

Clean the frothing unit as well as the
steam valve after frothing or heating
up milk. If the
steam valve allows only a reduced
amount or no steam or hot water to
pass through, we
recommend decaling in addition.
Caution! Risk to health through
milk residue on the frothing unit
and steam valve!
Contamination through dried milk
on the frothing unit as well as the
steam valve is a breading ground for
bacteria. Keep these parts of the
appliance clean at all times.
Caution! Risk of burning on the
frothing unit and steam valve!
The frothing unit as well as the steam
valve get very hot during the
frothing of milk or the preparation of
hot water, and can cause burns.
Allow these parts of the appliance to
cool down before starting cleaning.
Only hold the frothing unit by the
black cap.
Method:
1.
Remove the frothing unit and rinse
off the milk residue under flowing
water.
Subsequently wipe the steam valve
2.
with a damp cloth. Fig.47
Clean the air suction opening of the
3.
frothing unit if blocked by poking
the clogged opening carefully with a
pointed needle. Fig.48
4.
Now unscrew the outlet valve from
the steam valve. For this, use the
measuring spoon P with the
integrated took function. Fig.49
Clean the outlet valve by poking the
clogged opening carefully with a
pointed needle.
Then rinse thoroughly and check
that the valve is free. Fig. 50
To clean the steam valve, place a
container under the steam valve.
Turn rotary switch D "Hot
water/steam" into position and allow
hot water to pass
through briefly without the
screwed-on outlet valve. This rinses
out any
remaining contamination from the
steam valve.
GB
47